Metal printing can be applied to the automotive, aerospace, energy, industrial and medical fields, no matter which industry can hardly afford the damage caused by part quality problems. The key technologies involved in the quality of 3D printing parts are technology and materials. The topic of this issue takes SLM technology as an example to analyze the significance of the consistency of powder materials for metal printing.
The breakthrough of the metal powder atomization process has promoted the development of SLM technology, and the improvement of the quality of powder materials has directly promoted the application of metal printing parts. At present, the particle size range of powder commonly used in SLM is 15-53 μm, which requires the powder to have good sphericity, fluidity and low oxygen content. However, due to the difficulty in the atomization process, there are great problems in the quality of the powder.
1. Sphericity problem
During the preparation of metal powder, the powder particles will have different shapes according to the different preparation methods, such as spherical, nearly spherical, polygonal, etc. Powder particle shape directly affects powder flow and bulk density, which in turn affects the properties of printed parts.

Differences in Metal Printing Powder Morphology
Generally speaking, spherical or nearly spherical powder has good fluidity and can be laid into a thin layer, thereby improving the dimensional accuracy and surface quality of the part, and the part can also obtain high-density and uniform structure, which is the preferred raw material shape for 3D printing type. However, it should be noted that the particle packing density of spherical powder is small and the gap is large, which makes the density of the part small and will also affect the forming quality.
2. Hollow pasta and satellite powder problem
Hollow powder and satellite powder are a big challenge to the quality of materials. The existence of these two will lead to residual pores in the molded parts. Even after hot isostatic pressing, such holes are difficult to eliminate, which will affect the mechanical properties of the parts, especially the fatigue properties. Serious impact; the air entrainment caused by hollow powder will directly affect the material composition and printing stability.

3. Powder particle size distribution problem
Although the particle size index of 15-53 μm metal powder for SLM is easy to achieve, the particle size distribution of the powder will also affect the surface quality and mechanical properties of the part. According to research, within the same particle size range, the parts made of metal powder with bimodal distribution have the highest density.

4. Material recycling issues
The unmelted powder in the metal printing process can still be used as a raw material, but after a long-term high-temperature molding process, the oxygen content of the powder in the powder bed will increase to a certain extent, which has a greater impact on EBM. As the number of uses increases, the powder composition, particle size distribution, and particle surface morphology will change. However, the current research has found that the microstructure and mechanical properties of SLM formed samples have no obvious relationship with the number of powder cycles, while the mechanical properties of EBM formed samples have a significant relationship with the number of powder cycles. For this point, further research is still needed.

In addition to the above problems, metal powder materials also face problems such as uniform composition and oxygen content.
The development of the preparation technology of metal powder for 3D printing restricts the development of the 3D printing metal parts industry. In recent years, under the background of the rapid development of metal 3D printing technology, metal powder manufacturing giants have strengthened the development of special spherical powder products for 3D printing. , For the development of special materials for a certain product, a series of powders for specific fields and specific parts have begun to appear, which will not only intensify competition, but also help promote the safe application of metal 3D printing.





